Search models, users, collections, and posts
Puerto Rico Flag Coaster
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
Open in Bambu Studio
Boost
60
92
31
10
150
73
Released
Description
Puerto Rico Flag Coaster
I made this Puerto Rico Flag coaster for one of my co-workers. It is 100mm in diameter and 3mm thick. I printed threse on my Bambu Lab X1C printer. The profile settings worked just fine but you may find some better settings as I'm still learning.
I always put a cork adhesive pad on the back of my coasters that I get off of Amazon to help prevent slipping on the table. I am providing the link below in case you're interested in getting some.
I would appreciate it if you could review my coaster and print profile, Thank you and happy printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)