Three Hilt Lightsaber Stand

I needed a minimalist 3 hilt lightsaber stand that could handle heavier hilts (like Disney sabers) and this is what I came up with. This is a one piece design that can easily accommodate 3 lightsabers from Savi's worksop (if you have one, you know they can double as make shift boat anchors). This will print out in about 5 hours at 0.2mm and uses about 140g of filament. There is room on the bottom feet to add rubber pads if you choose. NO SUPPORTS, BRIMS OR GLUE NEEDED.

For those who would like a pop of color at the back drop of the display and/or are looking for even more structural rigidity, I have added a honeycomb version with a color swap option on Plate 2. PLEASE NOTE THAT THE HONEYCOMB VERSION IS NOT COMPATABLE WITH THE INSERTS LINKED BELOW…. unless you cut it out.

I am starting to add inserts for this lightsaber stand that can be found here:

• Jedi Order
• Sith Empire
• Old Republic/Sith
• Old Republic
• Rebel Alliance
• more to come!

Or you could always…