Search models, users, collections, and posts
Smartphone Stand
Remixed by
Print Profile(1)
0.2mm layer, 3 walls, 60% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
10
18
8
0
50
38
Released
Description
A smartphone stand I use for my iPhone 12 Pro Max. It is based on a phone stand by @Sem3D_136548. In contrast to the original model, the set-up angle is steeper here. I mainly use it for landscape mode.
Picture for comparison: in gray is the original model, in pink is my remix.
Depending on your printer, supports are not necessary. You could use tree supports for the overhangs. Also, if you want a smoother finish I recommend using adaptive layer height.
Additional tip: the heavier the stand is, the better (Infill ;))
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)