Search models, users, collections, and posts
Olfa Knife Holder for Honeycomb Wall - HSW
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
11
35
3
0
38
17
Released
Description
Simple holder for Olfa utility knives. This was based on the Olfa L-2, but I'm hoping they have a similar angle at the end for all their designs. If they don't then let me know if the comments and I can put in alternate design angles for specific models.
Print at 0.20mm or lower to not have a jagged angled edge.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (3)