Bambulab P1S / X1C Air Reflux

"AIR REFLUX"

now only 24mm thick

This is a model for guiding the warm air filtered through the activated carbon back into the build chamber.

Therefore, no additional cables and fans are necessary to filter the build chamber air when printing with ABS or ASA.

With many filament changes, you should open the slider every now and then to let the waste fall out.

For PLA prints, you can simply leave the slider open so that the waste falls out.

To improve sealing, you can press TPU filament into the recesses provided.

Then insert the sliding door from the inside and push it down with some pressure (the slot must be on the outside and bottom).

Now you can glue the base plate and the housing together.

On the fan side, I cut M3 threads into the holes of the back panel and attached the model accordingly with M3 screws. On the poop ejection side, I used slightly longer coarse thread screws.

I printed the model from PLA and so far I have not experienced any signs of resolution or deformation due to the warm air.