HelloKitty 2 冰箱贴refrigerator magnet

The refrigerator magnet is approximately 10cm in height.

The height of the refrigerator sticker is about 10cm.

I have designed the model with gaps between the parts to facilitate assembly, however, you will need to prepare glue.

When I designed, I reserved gaps between the parts, so assembly is easy, but I need to prepare glue.

I have allocated a magnet mounting position of 10.2mm, therefore, only magnets with a diameter less than 10mm can be attached.

The magnet installation position I reserved is 10.2mm, so only magnets with a diameter of less than 10mm can be attached.

I have provided multiple magnet mounting positions to cater to different magnetic properties of refrigerator surfaces and accommodate the installation of multiple magnets; however, a standard 10mm magnet should suffice.

I have reserved multiple magnet installation positions to accommodate different surface magnetic properties of the refrigerator. Normally, a 10mm magnet is sufficient.

If the refrigerator surface is flat, a 1mm thick magnet can be used. If the refrigerator surface has a curvature, it is recommended to use a 1.5mm magnet.

If the refrigerator surface is flat, a 1mm thick magnet can be used. If the refrigerator surface has an arc, it is recommended to use a 1.5mm magnet.

For optimal results, purchase a soft magnetic sticker with a 3M adhesive backing, similar to the one depicted in the image.

Buying a soft magnetic sticker with 3M backing adhesive like the one shown in the picture will have a better effect.

If you are pleased with the model, kindly show your appreciation with a free like and bookmark. Thank you for your support!

如果您对模型满意，请给个免费的点赞和收藏，非常感谢！
If you are satisfied with the model, please give a free like and collect, thank you very much!