Search models, users, collections, and posts
Honkai Impact 3rd [Head]
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
3 plates
Open in Bambu Studio
Boost
15
26
2
1
24
1
Released
Description
Content has been automatically translated.
Note: The original file of the model does not have a hole under the head, I added a negative part (4.1 * 4.1 * 10 cylinder) in the Bambu Slicer software. You can add the hole according to your needs. The hole I added is designed to match the 6637 connector I made for the Hello Kitty model.
Also, the 3MF model I used was set to 30mm high.
And, once you insert the red piece and white helmet, it is very difficult to take them off, it is best to install the eyes before pressing them in.
By the way, the antenna is very easy to break, or it can break when you remove the support...
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)