Search models, users, collections, and posts
Print Profile(1)
0.28mm layer, 2 walls, 20% infill
1.3 h
1 plate
Open in Bambu Studio
Boost
120
353
37
5
795
552
Released
Description
I needed an easy way to mount my webcam at a good height to monitor my prints. So I designed this simple stand to put the camera in a position that would allow a good view between the nozzle and the print bed of my Ender-3. The stand is about 13.5cm tall. It was designed to hold my Logitech C920, but it should work for any similar webcam designed to clip on top of a monitor.
This is an easy print with simple geometry and no overhangs. I printed mine at a 0.2mm layer height with 3 perimeters for extra rigidity.
Leave a comment if this works for your model webcam/printer.
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (37)