80s TV Nintendo Switch Display
Print Profile(1)
Description
Pieces in order of third picture: base (back left piece), screen (middle back piece), clip (right back piece), feet (left front pieces), intenna (right front piece.
To install: The screen slides into the base with the clip clipping into the base. The feet and intenna are optional but give the model more of a stylist look to it. The intenna doesn't attach but sits on top of the TV. Super glue is not needed but will help hold everything together, definintely recomend glueing the clip to the base.
To install the feet, there are 2 supports under the screen that needs to be removed, it can be a little hard to see but use a knife or something else with a small sharp point to peel it off (seen in last two pictures), DON'T WORRY about damaging the print. After peeling off the supports and sliding the screen into the base just screw on the feet.
This is made for the Nintendo Switch Oled. It will fit the original Nintendo Switch but with some wiggle room.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (75)