Search models, users, collections, and posts
Cable Connector Cover
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, adaptive
Designer
24 min
1 plate
Open in Bambu Studio
Boost
6
13
0
1
8
8
Released
Description
We had a cable jack sticking out of the wall in an area of the house that we worried would snag on one of the kids while they were running around. The wife wanted a cover for it, so I just did this SUPER simple half sphere with threads. It prints without supports and threads right onto the jack. There are two indents on either side to allow you to get a grip on the sphere when unscrewing it.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)