Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 0% infill
Designer
2.4 h
3 plates
Open in Bambu Studio
Boost
42
82
6
2
49
17
Released
Description
I tried to make a light box, also for printers without AMS.
Light strip should not be wider than 8mm, this fits perfectly into the clips. I would only use a white light if you print the label Coloured. Length of the band at least 50 cm. The lid can clip into the housing without gluing it, so you can also replace the light strip. If anyone has suggestions for improvement, just let them out, I would like to desser.
Thank you for downloading my design!
If you print it, I would love to see your results.
Feel free to share a photo, leave a rating, or suggest improvements.
Happy printing!
– ein_3d_druck
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)