Search models, users, collections, and posts
Transparent water tight vase
IP Report
This model is created by Make My Vase
Make Your Model
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
3.9 h
1 plate
Open in Bambu Studio
Boost
246
695
36
15
557
272
Released
Bill of Materials
Bambu Filaments
Select all
Description
Vase made by the make my vase tool with a print profile tuned to make it water tight. It is printed with PETG and a 0.6mm nozzle.
To make it as transparent as possible while also making it water tight, the wall thickness was increased and layer height decreased.
It should be water tight but depending on printer performance the results may vary. If there are small leaks it might be fixable by using something like nail polish or a clear coat to seal any small imperfections.
Make sure to test with water in a safe place to avoid damaging anything in the case of a water leak!
Powered by Make My Vase from MakerWorld (https://makerworld.com/makerlab/makeMyVase)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (36)