Search models, users, collections, and posts
A1 Cable & PTFE Tube Support Hook
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 7 walls, 60% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
63
143
27
14
217
168
Released
Description
Changed the “hook” to be more ring shaped to reduce friction when the PTFE tube and hotend cable are moving. The hook is also bigger than the original model, with a opening smaller than the tube and cable to prevent them from falling out.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (27)