Baby Yoda (Grogu) Christmas Tree Topper

WORK IN PROGRESS

Grogu levitating Christmas star tree topper. Available with and without Christmas hat. Use your existing Christmas lighting to illuminate Grogu and the Star. Best when lighting effect when printing using SLA resin printer.

V2:

• Added lighting hole in Grogu's arm
• Split Christmas star into two parts for easier printing
• added larger clearance in star for LED lighting
• Fixed issues with Christmas hat being hollow

Printing Notes:

• Ideally print Grogu with and without hat and star in translucent resin for better luminescence (not necessary)
• print both star components with flat side on the bed and use supports
• Print Support pin long side flat on print bed

Instructions:

1. once all parts are printed, glue all pieces together with super glue/hot glue. If printed in resin, parts can be stuck together using additional resin as glue
2. feed the tip of your Christmas lights through the bottom of Grogu and through the hole in his arm
3. pull the tip of the LED lights and gently wrap around support pin and into the Christmas star (can be hot glued if you want)
4. place the Grogu on the top branch of your Christmas tree
5. wrap the remaining length of the Christmas lights around your tree as normal
6. Gaze in awe at Grogu lifting a Christmas star