Search models, users, collections, and posts
Cup Carrier for tactical belt clip - heavy duty
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
12
36
2
0
26
6
Released
Description
This cup carrier is designed for heavy duty use.
You will need a tactical belt clip with 9 holes e.g. THIS
The 4 holes version should be faster to print and the clips anyway will only be shipped with 4 bolts, so I suggest to print this version.
Be aware that there are different versions of the clip available. This carrier is designed for a 19mm hole grid, will take rubber washer up to 12mm and a threaded sleeve diameter up to 5mm
The “negative” model can be used to create your own logo version.
Just load the generic cup carrier into a 3D modeller e.g. Microsfot 3D Builder, add the logo STL you want and merge them, then use the negative STL and substract it from the merged body to cut away again the additional Logo to the arcing of the carrier.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)