Search models, users, collections, and posts
Mars 5 Ultra Drip Holder
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
2.2 h
1 plate
Open in Bambu Studio
Boost
62
108
13
12
270
109
Released
Description
So nobody had a Mars 5 Drip holder that attached to the build plate, so I made one by scanning my build plate then modeling off that. Uses M3*18 SHCS plus a washer. I probably could have done countersunk but I am lazy and those were what I had on hand so thats what I made it to fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (13)