Search models, users, collections, and posts
Voronoi Dog Statue
Remixed by
IP Report
Print Profile(2)
Small holes 0.2mm layer, 3 walls, 15% infill
Designer
2.8 h
1 plate
Big holes 0.2mm layer, 3 walls, 15% infill
Designer
2.5 h
1 plate
Open in Bambu Studio
Boost
125
229
21
5
303
140
Released
Description
Voronoi Dog models, Approximately 117 mm tall and 100mm wide.
Best printed in PLA with brim, no support needed, set auxiliary part cooling fan to 100%. Scale the model to your heart's content.
You can try printing with Support for the muzzle as those parts are floating. It works without but can be a bit droopy, though nothing you can't snip away for a clean result.
This model is quite fragile, please be careful when removing it from the printbed.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (21)