Search models, users, collections, and posts
Cute Bear Desk Trash Bin Lion Flip Lid Waste Can
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
12.6 h
5 plates
Open in Bambu Studio
Boost
29
63
11
6
53
31
Released
Description
About
Desk trash can / waste bin with a choice of flip lids: choose between Bear, Mouse, or Plain lid designs. The bin (excluding lid) is roughly about 10cm / 4" in diameter and in height.
Printing
- Please refer to the uploaded print profile/3MF file for variable layer height, support and brim settings of the different parts.
- Good bed adhesion is required, especially for the dome-shaped parts.
- Choose between bear, mouse, or plain lid designs to print.
- Bear and mouse lids are pre-colored for two-color printing in the uploaded print profile.
- Tip: The uploaded print profile uses 0.2mm layer height. You can adjust the layer height smaller if you prefer a finer layer resolution for the dome-shaped parts.
Assembly
- There are 3 parts: outer lid, inner lid, and bin.
- After removing the supports and brims for the two lid parts, slide the outer lid over the inner lid.
- Fit the lid assembly onto the bin.
- The flip lid motion will be smoother after some use.
There are also Lion and Panda designs for this bin: https://makerworld.com/en/models/545808#profileId-463644
Please check out my other models too! Thank you.
__
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (11)