Search models, users, collections, and posts
Print Profile(0)
Add the first print profile to earn points
Boost
4
7
0
2
5
0
Released
Description
This is a model of a sponge holder that has a drain in the center and an elevated square on the top to help keep the sponge in place. My aim was to create a simple minimal sponge holder design to clear up clutter around the sink..
In the model there are actually two sponge holders side by side. they are not actually attached to each other and need to be supported independently. Best to lay them each on the most wide/large flat side than just auto support.
The model was printed with Bumat PLA Brown with Textured PEI Buildplate w/ 10% infill. However, this can be changed and model can be scaled without issues
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)