Search models, users, collections, and posts
Slim Spen Stick on holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
40
101
10
8
148
94
Released
Description
I got my Samsung Fold 6 crafted black and the rear was just to nice to cover. Got a clear case to display it, but i needed my spen.
So whipped this up. A simple low profile spen holder.
Simply print and stick on.
The spen will slide out the top. It is a WIP, currently holding my pen tight without falling out. But only time will tell.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)