Search models, users, collections, and posts
Full Frame HSW
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
41.5 h
9 plates
0.28mm layer, 2 walls, 10% infill
2.9 h
1 plate
Open in Bambu Studio
Boost
424
1311
154
104
2.4 k
978
Released
Description
I didn't like the existing framed HSW, so I designed a full-frame option in Fusion 360. It's a remix of the legendary Rosťa model, and everything is compatible. I personally printed it in Prusa ABS because I had a few unused spools lying around. But it should work fine with PLA, PETG, or ASA as well.
I organized and labeled every plate - don't forget that it's printed upside down. Therefore, the labels refer to where the pieces will be once finished and assembled.
Troubleshooting
Weak adhesion:
- PLA: Remove the top glass and open the door. Switch off the auxiliary fan (the big one on the left side).
- PETG: Make sure your filament is dry, use a 5mm brim with 0.05 gap.
- ABS or ASA: Print with a 10mm brim, 0.05 gap, using Bambu liquid glue stick.
Stringing:
- Make sure your filament is dry (weigh the spool, then dry in oven, reweigh - repeat until weight remains constant).
- Slow down the speed for the outer wall.
The profile is too big for for A1 mini.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (154)