Search models, users, collections, and posts
Dry Box Attachment Clip for Filament Swatch Card
Remixed by
IP Report
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Full plate - 0.2mm layer, 4 walls, 50% infill, no support
3.4 h
1 plate
Open in Bambu Studio
Boost
278
1203
165
85
859
568
Released
Description
Simple hanger with clip for the Filament Sample Card by 喵喵mya. I needed a way to attach it to my cereal dry boxes without it falling off, but still removable so I can use them with the AMS Swatch System by Mark'sMakerSpace.
Best printed in PETG for stronger clips, snug supports are needed for the hook section only.
Less than 3g filament. Attach to the dry box with some double sided tape or glue.
Hook swatch over and clip in. To remove, put a little pressure on one clip and lift the filament swatch out of place.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (165)