Search models, users, collections, and posts
Drinking Straw Holder for Dishwasher
Remixed by
IP Report
Print Profile(1)
PETG 15% infill, with brim
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
571
2589
116
41
1.4 k
1.1 k
Released
Description
This Drinking Straw Holder for Dishwasher can be used for multiple sizes of straws.
I noticed that some of my staws are too small for the original design.
In this remix, I just modified the bottom holes of the straw holder and replaced the holes with a cross. So smaller straws can't fall through the straw holder
This straw holder should fit for straws up to 11 mm in diameter.
It's not recommended to print it with PLA, because of the heat inside the dishwasher.
The holder can be attached to the dishwasher using cable ties.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (116)