Search models, users, collections, and posts
Box Orangizer
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
1
9
0
0
4
2
Released
Description
This is a Box Organizer, that can be used for anything, it's not that big it is only (133mmL*78.38mW*19mmH).
Below are the files in STL, & GCODE for the Model. I printed this on my Ender 3 and it came alright, although it had some warping because of the conditions it was in, overall it came out alright. I also used a 5% infill and some support on the inside to hold the top side overhang.
Just so you know, if you are using PLA to print this and you use support, it's super hard to get the supports off.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)