Search models, users, collections, and posts
Hand Propeller Toy
IP Report
Print Profile(6)
A1, P1, X1 3 color 1 set 0.2mm layer, 2 walls, 40% infill
Designer
35 min
1 plate
A1, P1, X1 Single Color 0.2mm layer, 2 walls, 40% infill
Designer
32 min
1 plate
A1 Mini Single Color 0.2mm layer, 2 walls, 40% infill
Designer
37 min
1 plate
A1 0.2mm layer, 2 walls, 40% infill
Designer
3.9 h
1 plate
Click to see more
Open in Bambu Studio
Boost
161
464
34
9
516
371
Released
Description
I've seen a few of these around and thought I would put my own take on it. The propeller has a slight taper on the end of the blades that gives it a little more weight on the ends allowing it to spin a little faster and longer than others. The profile has 8 sets on the build plate meant for X1, P1 and A1 series printers. These print directly on the platform with a small brim and minimal support. If you experience adhesion issues I usually just wash the PEI plate with water and a little bit of dish liquid. If it still doesn't hold, a standard glue stick works amazingly well and washes off easily with a little water.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (34)