Wii Remote Gun Holder for Lightgun Games

Fun accessory for your Wii shooting games. Holds an original Wii remote (without the motion+ add on). This supports use of the nunchuk if needed. Prints in 3 parts without supports and snaps togethers.

Assembly Instructions:

1. Place trigger on top of one side of the main gun, with the hole over the rod at the base of the handle. Make sure the top of the trigger is inside the gun.
2. Place the other side of the main gun on top, lining up the connector holes in the handle. Press the handle together part way, then squeeze the front

Wii Mote Insertion:

1. Thread the strap through the lower rear hole
2. Press the front of the Wiimote into the front of the gun at an angle
3. Press the back of the Wiimote down into the gun. The back of the gun will separate slightly then spring back once the Wiimote is fully inserted
4. Attach the nunchuk if needed

To remove the Wiimote, press up from the lower rear hole and reverse the process