Creality K1C filament spool side support lane V1

Have you recently printed the side support for the filament spool for your Creality K1/K1C/K1MAX printer but your filament spool gets stuck in the support???

Here's the solution, with this lane the filament flows smooth as oil up to the ptfe tube to enter your printer.

There are two solutions, one a little more expensive:

1. Print the support lane and the spacer, and with 2 of the 3 screws that you removed from the printer plate when you took it out of the package, hook everything into the two holes under the filament sensor on the back of the printer (ATTENTION: the measurements are precise for these specific screws) [RECOMMENDED SOLUTION]
2. Print only the support lane, but you will have to purchase two particular screws separately, they are: M3x8mm medium pitch countersunk screw (I want to point out that I have not tested this solution! This is only a second solution...)