Search models, users, collections, and posts
Star Wars Black Series Snowspeeder Stand
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 10% infill
Designer
5.3 h
1 plate
Open in Bambu Studio
Boost
28
39
23
15
69
43
Released
Description
Boost Me (for free)
Boosts are appreciated and free for you!
Tips are much appreciated as well!
https://ko-fi.com/disegnifugazi
This stand is for the Star Wars Black Series Snowspeeder. It slots into the openings for the landing gear as shown in the pictures. The stand prints in two pieces (no supports needed) that are connected using an M5x20mm bolt (you can go a bit shorter or longer if you don't have any of these handy). The stand allows you to tilt the speeder side to side as needed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (23)