Search models, users, collections, and posts
Jibbitz Buttons (No Supports!)
IP Report
This model is created by Image to Keychain
Make Your Model
Print Profile(3)
Regular Jibbitz (10mm)
Designer
51 min
2 plates
Small Jibbitz (7mm)
Designer
52 min
2 plates
0.2mm layer, 3 walls, 15% infill
Designer
31 min
2 plates
Open in Bambu Studio
Boost
53
159
12
2
261
124
Released
Description
Extremely fast and simple design of the Croc's Jibbitz buckle. NO SUPPORTS REQUIRED!
- 0.73g of filament
- ~3 min print time
- Thin Layer to prevent abrasion against feet
- Super glue required to adhere to Jibbitz
- Recommended to print in PETG or stronger. Found that some PLA pieces break after a couple of months
Print profiles:
Regular crocs (10mm hole)
Small, for knock-offs / variations (7mm hole)
Stronger (for larger/heavier jibbitz)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (12)