Search models, users, collections, and posts
Fidgetring Finger Spinner Print in Place
IP Report
Print Profile(1)
0.16mm layer, 4 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
10
37
17
1
106
116
Released
Description
Small fidgetring witch I originally made for my wife.
Inner diameter is 18mm
I will adapt it to your size!
My Printsettings:
Layerheight: 0.16mm (i think 0.2 should work, too)
Wall count: 4
Top/Bottom surface pattern: Concentric
You can try to print with concentric infill but in my case there are some “dots” with “internal solid infill”. The cleanest print in my case was with the settings mentioned above.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (17)