Search models, users, collections, and posts
Bottle Transfer Caps (3 common sizes)
IP Report
Print Profile(3)
PLA - 0.2mm layer, 4 walls, 20% infill
Designer
2.5 h
4 plates
Print By Object - 0.2mm layer, 3 walls, 20% infill
Designer
1.5 h
1 plate
Strength Profile 0.16mm layer, 6 walls, 25% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
1209
3518
464
280
4.5 k
3.4 k
Released
Description
These are transfer caps for shampoo, conditioner, soaps, lotions, etc. It has threads on each end. The almost-empty bottle threads onto one side (with the funnel) and then held upside down and threaded onto the new bottle (with the small spout). MAKE SURE THE OLD BOTTLE THREADS INTO THE FUNNEL SIDE OF THE TRANSFER CAP. Allow to sit over night, or however long it takes to empty the bottle.
I have made three sizes - large, medium, and small - I tested them on all of the bottles in my house, and they all seemed to work for the different size bottle necks. I am in the USA, and can't guarantee they'll fit bottles in a different country. Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (464)