Search models, users, collections, and posts
Print Profile(2)
0.2mm layer, without nametag slot
Designer
10 h
1 plate
0.2mm layer, no supports
Designer
10.4 h
2 plates
Open in Bambu Studio
Boost
216
703
31
21
755
290
Released
Description
A print in place magazine or file holder with a small nametag slot in the front. Nametag example included.
Build Plates:
Note:
If you see the warning “There are 4 non-manifold edges”, ignore that warning and do NOT repair the model. I created custom internal supports and Bambu Studio regards those as holes in the mesh. The model doesn't need any infil, while still being supported in crucial areas.
Happy printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)