D10 Kitcard V1

Greetings fellow adventurers,

Whether you need an emergency d10 or a quick little extra to put in a celebratory card for a fellow DnD’er, the “D10 kitcard” has you covered.

This d10 (V1) measures 16.5mm face to face and features a layout of which the opposite sides sum to 11.

Assembly Instructions (no glue required):

The joints of the pieces feature a slight dovetail design and require a bit of pressure to push into place. Once assembled it is not recommended to disassemble again.

1. Carefully remove each piece from the frame.

2. Gently bend the faces of the pieces inward.

3. Connect the 1-face to the 2-face as shown below so the 1-face will connect to the 2- & 6-face.

4. Subsequently push the 6-face into place, then the 3-face and so on, alternating between the faces of the upper and lower part.

And there you have your new D10!

Options:

In the print profiles you will find the following options:

• duo color with frame
• single color with frame
• duo color no frame
• single color no frame

Materials:

All these were designed and printed with PLA.

Comments on previous kitcard dice have pointed out that PETG has good results as well, but ABS does not.

Additionally PETG doesn’t leave the fold lines you get with PLA.

This does require some further testing, so if anyone tries it with PETG or other materials, please leave a comment.

Upcoming:

Kitcards for the D4, D6, D8 are in the works.