Search models, users, collections, and posts
R3D Paper Spool using Three Green Detachable Spool R3D used Sunlu PLA2.0’s spool
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
3
4
3
3
11
3
Released
Description
Content has been automatically translated.
To better utilize the R3D paper spool’s filament, a suitable adapter spool could not be found. After removing the side of the paper spool, the size was tested to be just right for the Three Green detachable spool. After placing the spool lid, it was found that it was 3 mm short, and the latch could not be closed properly. Therefore, this spiral adapter was designed to tighten the spool.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (3)