Stackable Box for Calliope Mini v3

Stackable box for the Calliope Mini in version 3 (V3). It was important to me that it was immediately clear whether all the important parts were included when students returned their set. Therefore, I did not use a lid.

The print profile is optimized for material saving. The lightning fill is sufficient in my opinion. Each box needs about 80 grams of PLA. I printed with the profile “0.12 Fine” and a 0.4 nozzle, as the font was not as clean in the standard profile and the cable holder was also worse. The cable holder is not optimal from below, but also not bad. Supports under the holder were not an option for me because the “scars” were also rough.

In short: Well suited for my purposes - I hope for yours too!