Ikea Pax Shelf Support with Cable - Screwing

This is a remix based on the project:

https://www.printables.com/it/model/699330-ikea-pax-shelf-support-screwing

I modified the reinforced supports for the passage of the cable for the ikea ÖVERSIDAN LED lighting

I recommend using 3 reinforcement supports with the cable passage on the left side and on the right side to use the original design.

I created a drilling template to move the support next to the 28mm LED bar so as to leave the LEDs in their original position and to remove the weight of the shelves from the fragile LED supports.

I leave you the link for the templates:
https://makerworld.com/en/models/622651#profileId-546797

⚠ Set up your filament well, perform calibrations, dry it and set the right cooling parameters.

I take no responsibility for the print quality of your filaments ⚠