Search models, users, collections, and posts
Peg Board wire holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
4.1 h
2 plates
Open in Bambu Studio
Boost
17
77
1
0
26
9
Released
Description
Holds spools of wire to a pegboard.
Prints best with supports
Wooden dowels:
I use barbecue skewers or chopsticks. Any stick smaller than 5/16 inch (9mm) diameter should work.
Pegboard attachment points:
For most strength, print with the 'side' down.
Fusion 360 Files
Based on the pegboard holders from "Make Anything's" youtube video
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
Yes
light (15%)
Notes:
Draft - 0.3mmrnInfill - Light (15%)rnSupports - YesrnrnYou could print slower and with more infill, but these settings are plenty strong. Took about 45 minutes to print each part.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)