24 CM Folding rc plane propeller

Print profile and files of the 9,5x7 Folding propeller by Itek on thingiverse. Adapted settings for printing to current generation of printers since the original model was posted in 2014.

Needed hardware:

2x M3 22mm screw and fitting nut.

Lower KV motor recommended (approx 1200~)

Warning:
Varying materials, print quality and more will make your print different from mine. It might break and throw knife sharp blades and harm you or somebody else. Make safe tests and make sure it will hold up for your purpose before you put it on a plane and go flying. I take no responsibility as to how these files/plans are used. Good Luck!