Search models, users, collections, and posts
Halloween Suspended Pumpkin
Remixed by
IP Report
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4.4 h
1 plate
0.2mm layer, 2 walls, 15% infill
4 h
1 plate
Open in Bambu Studio
Boost
35
65
7
5
85
34
Released
Description
Content has been automatically translated.
A bouncy, suspended pumpkin, approximately 12cm tall.
Using a 0.4mm nozzle, I recommend using the print configuration I provided (0.2mm layer height, select “Arachen” in the wall generator, and the no supports option do not change these, the rest can be adjusted as needed), scaling is not recommended.
After slicing, please ignore the path conflict warning. The suspended lines are quite fragile, so be extra careful when removing the supports! It is recommended to detach the model by gently bending the build plate, and then upright the build plate and remove the remaining adhered parts to retrieve the model.
Based on the Halloween Pumpkin model, a suspended frame was added.
Happy Halloween to all!
Boost Me (for free)
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (7)