Death Note Stash Book/Wallet
Print Profile(3)
Description
Boost Me (for free)
If you like this design please consider leaving a boost and check out my other work! <3
Introducing a stash book modeled after the notebook from Death Note! With print-in-place hinges, it opens like a real book and offers a discreet space for storing credit cards, ID cards, gift cards, and driver's licenses. Available in three versions: magnetic for 3x3mm or 3x2mm magnets, and a non-magnetic option. A practical and sleek accessory for any fan of the series! A great wallet alternative (but I don't recommend sitting on it!)
Poop Warning:
Two books will fit on one plate and reduce waste, you can enable purge into infill at the risk of color showing through the white of the pages.
If you have suggestions for a book you would love to see feel free to comment or DM me! :)
Check out my Large Witch's Stash Book here: https://makerworld.com/en/models/633896#profileId-559035
Pokemon Card Stash Books can be found on my profile: https://makerworld.com/en/@Empty_Dustpan
Storage compartment dimensions are approximately: 55.6mm x 88mm x 11mm.
The magnetic version requires 12 magnets - either 3x3mm or 3x2mm. (3x3 are recommended for strength)
The magnets I use for my small books can be found below (Unfortunately no Maker's Supply for these sizes):
3x2mm - Amazon Link
3x3mm (Recommended) - Amazon Link
Magnetic Version Instructions:
Simply add a small drop of superglue into each magnet hole with a toothpick before inserting each magnet, keeping the polarity of the magnets in mind.
Note:
It is very important to use dry filament and to keep an eye on the first few layers to prevent color bleed and make sure you are dialed in for good bed adhesion (bumping up the bed temp to 60 and cleaning the plate works for me).
Make sure the plate cools before removal to prevent warping! Removing black PLA prints before they cool can leave a white residue, and using a heat gun/torch to remove it will warp the print!
Filaments Used:
Sunlu Black PLA High-Speed
Sunlu White PLA High-Speed
eSun Bone-White PLA+
If you loved my Death Note Stash, you might enjoy some of my other models here:
 |  |
 |
 |  |  |
Disclaimer:
I am not affiliated with, endorsed by, or associated with any companies or entities that own the intellectual properties that inspire my 3D models. These models are fan-made creations intended for non-commercial, personal use only. All trademarks, copyrights, and characters remain the property of their respective owners.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (128)