Ship 33 Block 2 (1:100) Space X (two-tone)
Print Profile(3)
Description
This is a 1:100 scale model of the Starship 33 from Space-X,
It is a very detailed model, therefore also a large file.
Print time for all parts 17 hours 50min.
Material used: Bambu PLA Basic Black
Sunlu PLA + Silver
Assembly:
Print all parts and assemble them.
Test everything before gluing, and in which order the parts are arranged.
It is best to start with the hull.
Then slide the engine unit from below (pay attention to the recesses), then insert the engine shaft, again pay attention to the recesses.
Now you can assemble the tip (it is a little fiddly) and connect it to the hull, then attach the previously glued flaps.
To attach the upper flaps, a piece of filament about 70 mm long is inserted into the hinge holes and the excess end is cut off.
The lower flaps are inserted upwards and secured at the bottom with short M2 cylinder screws.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (236)