Search models, users, collections, and posts
SparkFun RFID USB Reader Plates
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
1
0
Released
Description
This thing contains a mounting plate and a drilling guide for the "SparkFun RFID USB Reader" (SEN-09963). The base plate is one mm thick. M2 5 mm or 1/4" 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter. The holes do not go through the lower layer to make it easier to print. You will have to drill them.
This thing is a complement to http://www.thingiverse.com/thing:328552 .
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)