Search models, users, collections, and posts
Wider KitchenAid Accessory Holder
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
74
230
16
8
213
124
Released
Description
Tired of broken accessory pegs? Me too! Try V2 for big improvements!
I really liked the El Farol's KitchenAid accessory holder. But, I found the fit a little snug. While wrestling with it one day, I cracked one of the posts.
So, I pulled the file into Fusion, and added about an inch (25mm) space between each post. Unfortunately, that means it won't print on an A1 Mini or other small form factor printer, but it should just fit on a X1 or P1 series or larger.
I didn't refactor the version with screw holes, but if there's enough demand, I can add one. Or, you can add them yourself in Bambu Studio by throwing in a couple negative cylinder primitives.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (16)