Adapter Rings for 250g Filament Spools for Bambu Lab X1-Carbon AMS (140-154mm diameter) - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

MediaMan3D

3D Printer>3D Printer Accessories

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 16% infill

Designer

1.8 h

1 plate

4.5(81)

0.6mm nozzle, 0.2mm layer, 2 walls, 16% infill

Designer

1.5 h

1 plate

4.6(5)

Open in Bambu Studio

Boost

220

490

1.3 k

902

Released

Description

Eryone spools are a different size (150mm diameter), so I modified the original design in a couple of ways. This should work for any filament spool that is 148-152mm in diameter and up to 4.5mm thick rim.

Resized for 150mm spools and the thickness of the spool sides (4.5mm).
Added 5m width spacer to each side ring to better fit in AMS (Amolen spools are very narrow).
Modified retainer clips to make it easier to install. Clips are specific to each slot in the ring.

Print 2 rings and 6 clips.

Print instructions

The attached 3MF file was created in BambuStudio.

Print the spool adapter x2, clips x6.

Assembly

Images also show the assembly process. Place the spool between the helper nubs in the adapter. Then from the inside of the spool, from the rim side, insert at three places the clips so it grabs the rim of the 250g spool and the inner part of the printed adapter. The clips are unique to each slot, they should snap in place.

Repeat this for the other side of the spool.

Make sure any irregularities from printing are removed from the outer rim of the spool extender.

Usage

Place the extended spool in the AMS spool slot, in the center. Roll the spool back and forth to make sure the rolling goes smoothly. Then feed filament in the AMS and use as normal.

UPDATE 12-16-2022: Added support for Stronghold and AMOLEN 250g spools.