Simple Rotating Dryer (Garbageman Edition) (Single Plate Heat Source 10*10 External)

Simple dryer made with recycled PETG (whole roll) (kex's transparent PETG in one piece) Hole clearance 0.2mm (please determine if sanding is needed)

bom as shown, the heat source uses a 10*10 heating platform (personally used Bangyun's 350w because this vinegar just wrapped the dumplings) You can add heat conducting pads (current heating platform 75 degrees, 50 degrees)

Fan optional, because it's theoretically unnecessary with built-in rotation, uses a 12025 fan, similarly, a fan theoretically doesn't need motor rotation

Voltage meter optional, you can adjust the fan speed by feel (connect the motor directly to 5V, low speed motor is recommended)

Comes with jayo's material tray adapter

It's recommended to prepare a soldering iron, solder wire, screwdriver with a flathead screwdriver, carving knife, and sandpaper