Search models, users, collections, and posts
Multiboard pen pot storage
Remixed by
IP Report
Print Profile(1)
Pegboard fitting 0.24mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
265
1202
77
34
1.3 k
690
Released
Description
A pen storage pot for Multiboard based on a design by eethansshen. It can be orientated to be printed without supports but this will result in very week pegs that are likely to fail. its for this reason the print profile is orientated on the build plate the way it is and is using supports.
Height: 64mm
width: 52mm
Depth: 110mm
Boost Me (for free)
If you like it feel fee to give a boost. If not then don't :)
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (77)