Filament rack storage
Print Profile(1)
Description
Boost Me (for free)
If you like my work, a boost is apreciated :) It cost you nothing and helps me continue my work :)
Fast print (2h) and only 144gr for the complete rack.
You just need 2 wooden sticks with a cross section of maximum 25mm / 1 inch.
Mine are 70cm / 27,55 inch in lenght.
If you dont like the honeycomb pattern, just change the infill or add top and bottom layers.
Holes are for M4 screws and tapered.
I recommend to use PLA-CF filament, but it should work fine with normal PLA as well.
If you are in doubt, just increase the number of walls or infill.
With a lenght of 70cm / 27,55 inch you can fit ~10 spools of filament. So its only 11kg / 24 lbs of weight.
But you can fit longer sticks without problems, the part itself, due to design, can carry a lot more weight.
I secured my sticks with doublesided tape.
If you're not using a 25mm / 0,984 inch stick, you have to rescale the "rack stopper"
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (73)