Magnetic Nails

Model Introduction:

A type of magnetically attachable nail, not only can it have multiple colors, but it can also be easily attached to the surface of magnetic metal objects. This model has been optimally designed, printing requires no support, and it is also super material-saving. Each one only needs about 1g of material;

In addition to saving printing consumables, it also saves printing time. If it is a single-color version, the A1 model only needs 25 minutes to obtain 4 magnetic nails;

The model has also been divided into plates, namely multi-color and single-color versions.

Magnet Assembly:

Under normal circumstances, glue is not required. If the magnet is assembled too tightly, place it on the table and press down slightly on the model to embed the magnet into the model.

The magnets are standard size, economically priced, easy to purchase, and can also be purchased from the Bambu website.

Magnet Size:

6mm*2mm Please note that each magnetic nail requires one magnet.

Finally:

The model has been tested, no skirt is added in the printing configuration. If you fail to print, it is recommended to clean the printing panel first; if you are pursuing high quality, you can add the smooth and adaptive modes using variable layer heights in the configuration file, and you will obtain higher printing quality.

I am looking forward to seeing everyone show off their colorful magnetic nails in the comments!

Wish you all a pleasant life, I will reply to any questions in the comments section in a timely manner.