5 Port Hub for the Kobra 3
Print Profile(1)
Description
A short 5 port hub for the Anycubic Kobra 3. The cap may be a little difficult to snap into place on the first try, but it ensures that it won't come loose during printing.
Requires low profile collets, which can be printed from here:
https://makerworld.com/en/models/672203
You'll need to use at least 1 of the small clips for the center port, a regular one won't fit. Use the thickest clips that you can fit in order to create a strong grip on the tubes.
You can also use regular non-printed collets but they need to be low profile ones similar to what the stock hub comes with.
~Recommended print settings~
Layer heights: Maximum of .1mm, lower would be even better.
Outer/Inner walls order
Arachne Wall Generator
No higher than 60mm/s for the outer walls.
Make sure to orient both pieces to print upside down, no supports.
The inside MUST be smooth, if you see any defects in your print, you'll need to clean it up before use to prevent jams.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (64)