Adjustable graphic card holder bracket - ASUS TUF
Print Profile(1)
Description
Min. height 66 mm
Max height 113 mm
No support need.
Boost Me (for free)
Instructions:
The TUF logo should be printed flat with a layer height of 0.2 mm.
Ironing on upmost surface (I set 30mm/s and 30% (I think the correct setting depends on the printer and the type of filament) I used P1P and PETG.
The adjustable inner rod is printed separately with a layer height of 0.12 to make the thread easy to rotate.
An 8x2 mm magnet can be placed in the bottom.
On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole.
High-speed printing is not recommended due to fine details, acceleration speed decelerated.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
Check out my other uploads and download and/or print them. RTX, AMD, ROG, Aorus, COD, Minecraft
!!!Make sure the print speed and temperature are set correctly for your printer and the filament you are using!!!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (19)